Laserfiche WebLink
• (2) Intersections. The property line radius at street or alley intersections shall be a minimum of 50 <br /> feet; and if the angle of street or alley intersections is less than 90 degrees, the planning <br /> commission may require a greater radius. <br /> (3) Curb line. Street or alley intersections shall have at least a 50-foot radius. Where the angle of <br /> street or alley intersection is less than 90 degrees, the planning commission may require both a <br /> greater radius and intersection design sufficient to accommodate turning movements of WB-50 <br /> vehicles. <br /> (c) Blocks and lots. <br /> (1) In general, proposed industrial sites shall be suitable in area and dimension for the type of <br /> industrial development anticipated both in the city and in the city's planning area. <br /> (2) The depth and width for lots within plats located inside the city limits shall conform to the <br /> applicable zoning district. <br /> (d) Building lines and lot coverage. Building lines for plats located within the city limits shall conform <br /> to the applicable zoning district. Building lines for plats outside the city limits but within the <br /> planning jurisdiction shall conform to the following: <br /> (1) Building lines and setback lines shall be a minimum of 50 feet from all industrial street right- <br /> of-way lines and a minimum of 70 feet from all arterial street right-of-way lines.A minimum of <br /> 30 feet of setback shall be provided on all other property lines. <br /> • (2) Half of any adjacent permanent open space or easement retained by the grantor for utility or <br /> other purposes or dedicated to the public shall be allowed as part of the required 30 feet of <br /> setback, except that in no case shall the total separation between buildings on adjacent tracts or <br /> lots be less than 60 feet. <br /> (e) Provision of open drainage. The following improvements and requirements are alternatives in lieu <br /> of curb and gutter and underground drainage: <br /> (1) Pavement width for minor streets shall be a minimum of 28 feet with six-foot shoulders. These <br /> shoulders shall be designed to meet at least 75 percent of the design requirements for the <br /> pavement.A double-surface treatment may be used for these shoulders. <br /> (2) Open drainage ditches will be permitted in street rights-of-way or easements, provided they <br /> meet the following requirements: <br /> a. The side slopes shall commence a minimum of six feet of subgrade from the edge of the <br /> paved driving surface to permit the six-foot shoulders. <br /> b. The side slope for both slopes of an open ditch shall conform to the requirements of the <br /> master drainage facility plan. <br /> c. The maximum high water ditch elevation for designed capacity shall be a minimum of six <br /> inches below the bottom of the base of the shoulder. <br /> d. Right-of-way width shall be a minimum of ten feet beyond the top of the backslope <br /> requirements. <br /> -182 - Batesville Subdivision Regulations <br />